Hid EDGE EVO EIM-M Input Module Installation Guide Uživatelský manuál stáhnout pdf

Speciﬁcations

CONDITIONS VOLTAGE DC (VDC) CURRENT (Amp) POWER (W)

OPERATING

TEMPERTURE

CABLE LENGTH

UL REFERENCE

NUMBER

Inputs

DC Input (NSC)

+12VDC 0.03 Amp 0.36

32° - 122°F

(0° - 50° C)

Input Circuits

500 ft (150 m) = 22 AWG ● 0.65mm ● 0.33mm

18 AWG ● 1.02mm ● 0.82mm

Hi-O CAN Bus Total Length 100 ft (30 m) -

22 AWG ● 0.65mm ● 0.33mm

Maximum between drops 30 ft (10 m)

22 AWG ● 0.65mm ● 0.33mm

MEIMAxNN

X = K for Black

G for Gray

+24VDC 0.03 Amp 0.72

DC Input (MAX)

+12VDC 0.04 Amp 0.48

+24VDC 0.04 Amp 0.96

Supervised Inputs (MAX) 0 to 5 VDC Reference 0.005 Amp (Sink) 0.025

NSC = Normal Standby Condition

Wiring

Input 1 Input 2

10 P3 1

Hi-O Group Select Jumper

Short = Group 1, Open = Group 2

Outside Door Inside Door

( )

4 P1 1

Input 3 Input 4

-+-+-+

* Internal Optical Tamper Disable Jumper

CAN V+

GND

CAN H

CAN L

CANbus

Internal Optical Tamper

To disable the internal optical tamper sensor, attach a jumper wire from P3 pin 1 to P3 pin 2.

Note: If desiring an external tamper, wire an unsupervised Normally Closed contact, and replace the jumper.

EDGE EVO

Input Module

EIM-M

InstallatIon GuIde

82340-901, Rev C.2

March 2013

15370 Barranca Parkway

Irvine, CA 92618-2215

USA

Optional

Supervised Inputs

1-6K

N/O

1-6K

N/C

1-6K

N/O

Designed for interfacing to general purpose inputs typically not associated

with standard access point control, the Input Module provides an interface

to four input analog/digital inputs. The module is always congured as

general purpose input.

1 2

EDGE EVO 1
Regulatory 2

Shrnutí obsahu

Strany 1 - EDGE EVO

SpeciﬁcationsCONDITIONS VOLTAGE DC (VDC) CURRENT (Amp) POWER (W)OPERATING TEMPERTURECABLE LENGTHUL REFERENCE NUMBERInputsDC Input (NSC)+12VDC 0.03 Amp

Strany 2 - Regulatory

RegulatoryULConnect only to a Listed Access Control / Burglary power-limited power supply, or Listed Access Control / Burglary PoE (Power-over-Etherne